How To: Disassemble Your Xbox 360

Original XBOX and XBOX 360 Hacks, Mods, and General Discussion.
User avatar
MattMan
Site Admin
Site Admin
Posts: 1467
Joined: Thu Aug 25, 2005 12:00 am
Location: New York
Contact:

How To: Disassemble Your Xbox 360

Postby MattMan » Wed Jun 24, 2009 3:58 pm

1. Remove Xbox 360 Faceplate
as shown below
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open1.jpg">
<P>2. Remove the bottom left
rubber from case.
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open2.jpg">
<P>3. Follow the instruction to
insert the XCM opening tool or very small flat head screw driverto the square hole (insert it close to the edge of
the hole then turn right as pictured in figure A, and turn left as it shows in
figure C)
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open3.jpg">
<P>4. Push the XCM opening tool or very small flat head screw driver
into the base grill to take off the right heat panel.</FONT></P>
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open7.jpg">
<P>5. Push the XCM opening tool or very small flat head screw driver
to the base grill to take off the left heat panel.</FONT></P>
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open8.jpg">
<P>6. Take the heat panels
apart.
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open9.jpg">
<P>7. Remove Microsoft
Sticker/Seal
<P><FONT face="Arial, Helvetica, sans-serif"><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open10.jpg">
<P>8. Undo the 4 Buckles on the
Front of the console.</FONT></P>
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open11.jpg">
<P>9. Push the XCM opening tool or very small flat head screw driver
into the indicated holes, press hard to let the top and bottom panels pop
apart.
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open12.jpg">
<P>10. Pull apart the 2 halves
of the Xbox 360 case.
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open13.jpg">
<P>11. Remove the DVD Drive
eject button. (Pull out)
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open14.jpg">
<P>12. As indicated by the
arrows, remove the 6 screws by using a TROX 10 driver.</FONT></P>
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open15.jpg">
<P>13. Remove the DVD drive
bezel..
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open16.jpg">
<P>14. You are Done!! (All
parts shown below)
<P><IMG src="http://turdinc.kicks-ass.net/Msntv/ps2/images/open17.jpg">
Image

Return to “Xbox”

Who is online

Users browsing this forum: No registered users and 1 guest